RF-Max Digimax 210 Guía de usuario descargar pdf (Pagina 7)

RF Receiver Led’s (indicators) :

Red Led :

‘flashing’ : indicates receiving an RF signal

‘steady on’ : indicates a fault condition e.g. RF signal

not being received

‘slowly plusing’ : indicates a valid install code has been

received

Green Led :

‘steady on’ : - indicates demand for heat

‘off’ : - no demand for heat i.e. heating call

satisfied

b) Checking the hard wired circuit :

1. Rely the RF-Max receiver to the mains. Check that no ther-

mostat in the heating network request warm. The red LED

should be off.

2. Press the Test button. The Green Led should come on.

Check that the boiler and/or motorised valve have been

operated. Remember to allow adequate time for the valve

to open. Press Test button again. The green led should

go out closing any valve and switching off the boiler.

Nota : the thermostat automatically leaves the test mode

after 15 minutes.

c) Checking the RF circuit

1. To install thermostat with the RF receiver press and hold

the OK and COPY keys together in Auto mode for 3

seconds. The DigiMax 210 will then transmit its unique

digital code every 10 seconds for the next 5 minutes. The

display will show flash ‘]]]’ while this is happening.

1 2 3 4 5 6 7 8 9 10

Sin comentarios

RF-Max Digimax 210 Guía de usuario Pagina 7